pipe fittings manufacturer

 At present most of brass connector is made of stainless mesh material, and its use scope is wide. Card sleeve joint application materials sel ection decision function, so under the condition of some special medium, it also have some pipe fittings manufacturer special needs, such as plus Design of coating, anticorrosive design, practical design, the application of professional level design, in many special purpose plays a very important role, has the very common card sleeve joint functional significance.
Different material at the beginning of the design of function orientation, there is the use of accurate, effect is more obvious, advantage of stronger and professional. Brass connector products application effect is very clear, and under the condition of large pipe to use more, all-in-one valve Coordinated with door shell is also easy to install. Card sleeve joint of cemented carbide products, high compression capacity, and the chemical stability is strong, is a type of products is very popular for many consumers. And in the actual production practice.
Showed a strong professional strength, as well as some of the plastic material also has applications in the field of special.
Brass joint repeat installation, all card sleeve joint can be heavily for many times, but no damage and clean to ensure that the parts:
1, inserted the steel pipe joint body until the card set against joint body cone, tighten the nut by hand.
2, using a wrench, tighten nut until the tightening torque increases tube fitting manufacturer sharply, tighten 1/4 to 1/2 turn again can.
Check: to remove the steel pipe inspection assembly eligibility requirements: card on the end of the steel pipe should be uniform slightly raised. Card can't slide back and set, but allow a slight rotation.
Brass pipe connection setup reuse techniques:
1, saw the appropriate length of seamless steel tube, clean up the port burr. Steel pipe end to axis and the vertical, Angle tolerance is not more than 0.5 degrees. If the pipe need to bend, the pipe end to bending parts of the straight line length can not less than three times the length of the nut .
2, the nut and the condom on the seamless steel tube. Pay attention to the direction of the nut and the set of, don't pack inside out.
3, in preassembly thread joint body coated with lubricating oil and the card case, insert the tube into the connector body, (steel tube) if I want to plug screw the nut by hand.
4, tighten the nut until the card sets of sticking steel tube, the 14 tube fitting turning point can feel (pressure) with the increase of the tightening torque. 5, after reaching pressure point, the nut tighten 1/2 circle again.
6, preassembly connector body will be removed, check card edge set of embedded, visible processes need to fill the space of card sets of front end. Card sets can rotate it slightly, but not the axial movement.
7, installation, install the actual joint in the body of the screw thread coated with lubricating oil, the gland nut and cooperate with screw until can feel tight force increase, then tighten 1/2 circle installed.